FAQ – Frequently asked questions
Frequently asked questions about our products
Do you have a question about one of our products? Take a look at our FAQ, you will often find the right answer here.
easy2-MOB
Check that the magnet switch is set to “ARMED”.
After that all buttons are active.
Also when you put the unit inside your life vest, get sure that you ARM the unit.
Only then it can activate in an emergency case.
Reason:
New regulations for AIS DSC MOB devices require a deactivation functionality.
This is done with the magnet switch on the easy2-MOB device.
Within the easy2-MOB unit you can programm up to eight MMSI numbers.
Just download the easy2-MOB app for your mobilephone:
Android:
easy2-MOB
iOs:
easy2-MOB
Activate Bluetooth on your easy2-MOB unit:
1. Push the yellow magnet switch to the left to “ARMED” if not done yet.
2. Press TEST button as long until the white LED stays on
3. Open the App you downloaded before, activate Bluetooth on request
4. Follow instructions within the app to programm the MMSI numbers
5. If you see an MMSI number with 211002010 this is our trial number, you can delete this one
Note:
If you don´t programm any MMSI number into your device, the unit will go into Open Loop directly after actviation in an Emergency case.